Short answer first, then the reasoning. Do it in two steps and it stops being confusing. First concentration: 10mg into 2ml is 5mg/ml. Then volume: a 0.5mg dose is 0.5 ÷ 5 = 0.1ml. Then units, and this is where people go wrong — a U-100 syringe is graduated in hundredths of a millilitre, so 0.1ml is 10 units. The word "units" has nothing to do with milligrams; it is a volume marking that exists because insulin happens to come at 100 units per ml.

pete_manc_UK said:

Do it in two steps and it stops being confusing.

That is correct as far as it goes, and here is where it stops going. The arithmetic is right and one caveat matters: a U-40 syringe changes the markings, not the volumes. If someone hands you U-40 and you read it as U-100 you will be 2.5 times out, and that error has a direction — it is always an overdose.

LarryQC_SD said:

Two of us with identical vials and identical diluent arrived at different unit counts, which means one of us has a conceptual error rather than a…

Can confirm the pattern LarryQC_SD describes. Concentration choice is a precision decision, not a preference. Reconstitute high and every dose is a tiny volume where one unit of syringe error is a large fraction of the dose. Reconstitute low and you get more graduations per dose, so the same hand tremor costs proportionally less. Against that, more diluent means more benzyl alcohol and a shorter comfortable in-use window.

From the other side of the consultation, briefly.

Just received my dosing arithmetic order — packaging review:

• Outer box: plain brown, no medication identifiers (discreet) ✅
• Inner insulation: Styrofoam with 3 gel ice packs ✅
• Temperature: vials were cold to touch on arrival ✅
• Labeling: lot number, BUD, compound name, concentration ✅
• Included: COA, reconstitution instructions, dosing card ✅

This is what professional compounding pharmacy shipping looks like. If your order arrives without these basics, reconsider your vendor.